100% Lainer Suspension Racing design.
This vacuum pump has been built after many years of experience in the suspension field looking for the maximum technology in the world of vacuum. It extremely speeds up the process to bleed the shock absorbers: between 4 to 5 minutes, only one cycle required.
Unlike other common vacuum pumps, we only use specific fittings designed for the vacuum system. Many vacuum pumps in the market use compressed air fittings which, after a while, can have an effect on the correct bleeding process leaving air inside the shock absorber.
We devoleped a manual system to allow the operator to utilize the vacuum pump with two different methods:
- Keep two different types of oil using the dual tank design, the same tank will be used both for the bleeding and refill process. This method allows the operator to always have two types of oil ready for the refill process. It’s very useful for those who use (for example) both the SAE 5.0 or SAE 2.5 based on their need.
- How it’s born the system: keep only one type of oil. The empy tank is always in vacuum and the tank with the oil inside always in pressure. This process will be even faster since the shock is connected to the tank already in vacuum.
It’s included of the connectors for the most common shock absorbers:
Always remembering that the absolute vacuum doesn’t exist, to obtain the maximum possible we developed the bleeding system from the bladder and NOT from the compression adjuster as many other systems on the market.
For shock absorbers with free piston (like WP, Ohlins, Mupo, …) we supplied the steel fitting with the specific thread and diameter for the existing hole on the shock itself.
For all the shock absorbers without hole, you can use our Tool Milling Kit M5 to make the hole, the thread and refill the shock using the fitting supplied with the vacuum pump.
Dimensions: 580mm x 344mm x 194mm
IMPORTANT: The machine is 220 Volt with a Shuko plug. For any different voltage you need a voltage converter.
To purchase call or email us.